What should I do if my smart device produce noise? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)

July , 2024

1. Verify that the connected load does not exceed the rated power capacity of the smart device.

2. Disconnect the load wire only (keep the other wires connected) and turn on the power. If the noise persists, it's likely originating from the load itself, and you should consider replacing the load device. If the noise stops, it suggests the issue is with the smart device. In this case, please reach out to ELEGRP's customer service for further assistance.

Was this article helpful?

  • YES

  • NO

0 out of 0 found this helpful

Thank you for your feedback

Have more questions? Submit a request

Topping