1. Verify that the connected load does not exceed the rated power capacity of the smart device.
2. Disconnect the load wire only (keep the other wires connected) and turn on the power. If the noise persists, it's likely originating from the load itself, and you should consider replacing the load device. If the noise stops, it suggests the issue is with the smart device. In this case, please reach out to ELEGRP's customer service for further assistance.
Was this article helpful?
-
YES
-
NO
0 out of 0 found this helpful
Thank you for your feedback
Have more questions? Submit a request
-
Does this device record power consumption? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)
-
Why do I need to set minimum brightness? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)
-
Can I use the Smart Dimmer Switch to control a motor-operated appliance? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)
-
Can the Smart Dimmer Switch be used with non-dimmable bulbs? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)
