Neutral wires are usually white, and ground wires are green or bare copper. The line wire can be identified by using a test pencil; it glows when the power is on. The load wire is the one that does not cause the test pencil to glow. Always turn off power at the circuit breaker before labeling.
Was this article helpful?
-
YES
-
NO
0 out of 1 found this helpful
Thank you for your feedback
Have more questions? Submit a request
-
Does this device record power consumption? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)
-
Why do I need to set minimum brightness? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)
-
Can I use the Smart Dimmer Switch to control a motor-operated appliance? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)
-
Can the Smart Dimmer Switch be used with non-dimmable bulbs? (ELEGRP Smart Dimmer Switch: DPR10, DPR30, DTR10, DTR30)
